4. Calculating (and plotting) rate versus time for an `EventTable`¶

I would like to study the rate at which event triggers are generated by the ExcessPower gravitational-wave burst detection algorithm, over a small stretch of data.

The data from which these events were generated contain a simulated gravitational-wave signal, or hardware injection, used to validate the performance of the LIGO detectors and downstream data analysis procedures.

First, we import the EventTable object and read in a set of events from a LIGO_LW-format XML file containing a sngl_burst table

from gwpy.table import EventTable
events = EventTable.read('H1-LDAS_STRAIN-968654552-10.xml.gz',
                         tablename='sngl_burst', columns=['peak', 'snr'])

Note

Here we manually specify the columns to read in order to optimise the read() operation to parse only the data we actually need.

We can calculate the rate of events (in Hertz) using the event_rate() method:

rate = events.event_rate(1, start=968654552, end=968654562)

The event_rate() method has returned a TimeSeries, so we can display this using the step() method of that object:

plot = rate.step()
ax = plot.gca()
ax.set_xlim(968654552, 968654562)
ax.set_ylabel('Event rate [Hz]')
ax.set_title('LIGO Hanford Observatory event rate for HW100916')
plot.show()

(png)

4. Calculating (and plotting) rate versus time for an EventTable¶

4. Calculating (and plotting) rate versus time for an `EventTable`¶